Chevy Corvette Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
23 Posts
Discussion Starter · #1 ·
Hello Everyone,
I just replaced the rear spring bushings in my 81. Problem is: I do not know how tight to make the nut. I tightened it enough to get the cotter pin through the hole, but how tight do I make it? Its not a castle nut, just a regular nut. I have the repair manual and the AIM but they do not say anything about how tight to make the spring bushing bolts.:doh:
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top