Chevy Corvette Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Good Morning all. I am swapping an LT1 into a C-3. The LT1 is from a Firebird with the A/C on the lower passenger side. I understand the serpentine systems must be changed. Will the serpentine system on a TPI work?
 

· Registered
Joined
·
10,507 Posts
Good Morning all. I am swapping an LT1 into a C-3. The LT1 is from a Firebird with the A/C on the lower passenger side. I understand the serpentine systems must be changed. Will the serpentine system on a TPI work?

I would think your best bet would be to swap the LT1 engine with all of it's components into the C3 so you can retain it's serpentine belt system.
 

· Registered
Joined
·
217 Posts
the front drive on the LT1 is completely different from the tpi just look at the water pump. use the LT1 drive assembly and bolt it I'm with the existing mounts, you will need to adapt the trans mount.:thumbsup3:
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top