Chevy Corvette Forum banner

Got my rear

1332 Views 2 Replies 2 Participants Last post by  95vette
I picked up a Dana 44 3.45,rotor to rotor.Took a little over a hour to drop it off the old car,which caught fire(nitrous).I feel as if I can do this job myself,Thinkin of dropping the other axle and using the one I picked up.Dont know about the VSS gearing though.
1 - 3 of 3 Posts
On second thought ,looks easier to switch just the differential and batwing,but I like to use the half shafts which areDennys nitrous ready
It is actually an easy swap. You will need the D44 batwing as it does not bolt up to a D36 batwing. Then you also need the D44 driveshaft and C-beam. The half shafts are interchangeable. Good luck with it, I am sure you will be pleased with the results.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top