Chevy Corvette Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
From Another Forum:

Perfect time for a carburetor choke Issue especially since I live in Los Angeles and it's been 100+ degrees. When starting my engine after sitting overnight I press the accelerator one time and the choke butterfly closes. I turn the key and the engine roars to life and the RPM's indicate that the choke is functioning as it supposed to for about 2 seconds and then the RPM'S drop and the engine sounds as if it is starving for gas. I have a poor idle almost stalling for about minute then the RPM'S sneak back up to the original fast idle speed and I can drive off. Within a short time the choke comes off and I can cruise around happily the rest of the day.

Could it be fuel is leaking from the bowls overnight and during that first start of the day it takes the fuel pump that extra time to refill them. Where would the gas go? I see no evidence of gas leaking from the carb plumbing. Any trouble shooting suggestions would be appreciated.


This is why I recently installed a push button fuel bowl priming switch. I found after a hot shut down the fuel was boiling and evaporating so much my fuel bowls were nearly empty the next morning. As my late model Street Avenger has sight glasses I could see the fuel levels were way below the sight glasses. My front bowl still had enough fuel for the accelerator pump to work and start my engine but not enough fuel to keep it running long enough for the pump to fill the bowls. Ever since I installed the push button switch my choke and fast idle operation has been flawless.

I installed my push button switch on the right side of my parking brake console:
The hardest thing to do is "diagnose over the phone" but I would want to know if needle valve(s) are seating. As to the cold start the choke is suposed to be involved with the idle alot longer than a few seconds. I would suspect the choke setting.
 

·
Registered
Joined
·
2 Posts
Perhaps I should tell you alittle of myself. I was raised next door to my father's repair business, Val's Auto and Truck Repair, I started wiping tools before I was old enough for Kindergarden. I reached first class at the age of 17, not by Father but when he threw me out " you don't know how good you've got it" but by Quaker City Dodge in center city Philly. Eventually he somehow talked me into buying the business and it was quite successful up until the day I sold it.
I'm not bragging when I say there's nothing on your vetted I can't fix, but diagnosing over the phone is one of the hardest thing this NIASE and ASE certified Master Tech has ever tried to do. BUT Jjust for shits and giggles you might look down the throat of that carb right after hot shutdown and see if it's dripping, just a thought. BTW, my nickname
WAS Corvette Bob I know them, owned them and sold them, anyway good luck with your toy. CVal
 
1 - 2 of 2 Posts
Top