Chevy Corvette Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I purchased a 1959 Corvette that had a frame off restoration in 1994. At the time of the restoration, a brand new convertible top was installed. I tried to deploy it recently and found that, when the rear is attached, there isn't enough "stretch" in the top to allow me to connect it to the top of the windshield. I'm assuming it worked properly when originally installed, so I am hoping someone can help me figure out what the problem is and what (if anything) I can do about it. Thanks in advance!
 
1 - 1 of 1 Posts
Top