Chevy Corvette Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
my project 71 corvette has damaged front clip . I found nice from 68 C3.
question :
are any differences in clips except side grills ?
is it possible to replace side cutouts on 68 with cutouts from my clip to keep it correct for 70-72 model
 

· Premium Member
Joined
·
9,061 Posts
the front grilles are also different..are yours reusable? if you check prices on those grilles, about $700 ea. ...but yes, depending on your skill level, you can cut the fenders at the bonding strip , along the door gap, and over the wheel, and put in yours ..
 

· Registered
Joined
·
10,519 Posts
the front grilles are also different..are yours reusable? if you check prices on those grilles, about $700 ea. ...but yes, depending on your skill level, you can cut the fenders at the bonding strip , along the door gap, and over the wheel, and put in yours ..

My '68 has a '70 front end on it and I had to buy the two front grills as mine were smashed. A staggering $1350 for them................
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top