[JOSE'S 79]

Started reinstalling my interior. Having a problem with the seat cushion. I got them off no problems but I cant get he new ones back on. Is there a trick or special tool that I need to get the new cushions on the seat frames?

[toobroketoretire]

Originally Posted by JOSE'S 79

Started reinstalling my interior. Having a problem with the seat cushion. I got them off no problems but I cant get he new ones back on. Is there a trick or special tool that I need to get the new cushions on the seat frames?

If you're trying to put the cushions on with the seats still bolted down you're never going to do it. You need to take the seats clear out...................

[fishslayer143@yahoo.com]

the new foam is thicker..make sure the foam is not interfering with the wire that goes into clip.. trim if necessary.. you can also bend the wire out slightly to make it easier.

[JOSE'S 79]

Yes the seats are out of the car and taken apart. I want to fit them before i re-dye the seats. Read this post after all the frustration, i did have to remove foam from the bars and bend the bars catch the mount better. I think it will be easier to do if the two seats half’s are back together. The factory manual says to use a screwdriver with a "V" notched in it to push on the bars. I got on a top piece on and those are the hardest so hopeful it will go well. What have you guys used as sound deadener?

[crossflag]

Get the new covers nice and warm, a hand held hair dryer works great. keep heating any problem areas and every thing should should turn out great...

[JOSE'S 79]

the covers are on. i was asking isf there are any tricks on getting the cushions on to the seat backs and seat bottoms. manaul says to use a v notched tool. to push the bars past the clips. i notches an ould screw drives and works great.

second question: i removed the seat rails to sand blast and refinish. one seat of rails is taller then the other. which on goes on what side?

[toobroketoretire]

Originally Posted by JOSE'S 79

the covers are on. i was asking isf there are any tricks on getting the cushions on to the seat backs and seat bottoms. manaul says to use a v notched tool. to push the bars past the clips. i notches an ould screw drives and works great.

second question: i removed the seat rails to sand blast and refinish. one seat of rails is taller then the other. which on goes on what side?

The seat-adjust chrome balls both go on the right side...................

[JOSE'S 79]

thanks to broke. one seat is taller then the other cause one of the rails is taller then the other when bolted to the bottom. which seat goes on what side?

[toobroketoretire]

Originally Posted by JOSE'S 79

thanks to broke. one seat is taller then the other cause one of the rails is taller then the other when bolted to the bottom. which seat goes on what side?

I just realized you have a '79 and I was referring to the seats in my '68 and '71. Both have their adjustment knobs on the right side and the seat rails are the same height on both sides.

How much taller? I just looked in my Corvette Central catalog and it only shows the seat rails for the '68's thru '78's (???). I suggest calling the tech department at Corvette Central at (800) 345-4122 and ask them

[JOSE'S 79]

i found a set of seats on Ebay and the taller seat rails are on the drivers side.