Forums - View Single Post - 4L60E Build Up Thread From FLT
View Single Post
Old 01-04-2009, 05:58 PM   #14
Vince @ FLT
Smokin Manufacture
Vince @ FLT's Avatar
Join Date: Oct 2008
Location: Bloomingdale Ill.
Posts: 112

Next we install the clutch pack for the reverse input clutch. The first plate to be installed will be cushion plate. It will be installed cone side up. Here are the photo's.

Next is to install the first steel. This will be followed up with by clutch and then repeated until all four steels and four clutches have been installed. Here are the photo's.

The next step is to install the pressure plate and the snap ring. Here are the photo's.

In the next set of photo's I will show how I preset my end play by using the pump stator. Also I will cover the machine process of our pumps along with the assembly of the pump. Enjoy the photo's and stay tuned. More to come. Vince
Vince Bielanski @ 1-630-350-7776
No Core Deposits All Transmissions Are Shipped Fully DYNO TESTED SEE Picture below
All Units Come Complete As A Bolt In Application. With Bell Housing And Tail Housing
Vince @ FLT is offline   Send a Private Message Reply With Quote