Here are results from our in-house ZO6 build with APS TT's on a forged motor.

http://img146.imageshack.us/img146/6144/redlinettzo69psig2up8.jpg

Next step is 12 psig and after that will be 15 psig!

We are bringing the car to Englishtown to finish a article with GM High Tech Magazine to do some passes before we step up the boost again. Will most certainly post the results!

Howard

:drool5: :drool5: :drool5:

its one thing to look at this curve and say to yourself, "wow 550ft/lbs @ 3000 and 700ft/lbs just a couple HUNDRED more rpm, but this car must be ridden in or driven to be believed! :party:

great numbers!! from a fellow dyno dynamics owner !

howard, seen both cars in coopertown, hope you'll post video from englistown good luck

Haven't been on the site in a while!

Here is the article that ran in the February issue;

http://www.gmhightechperformance.com/tech/0902gmhtp_2006_chevrolet_corvette_z06_twin_turbo_k it_install/index.html

Our new site is getting "evolved" everyday and the video section is next;

www.redline-motorsports.net

Little bit of the photo/track shoot stuff in the opening flash.

The Cooperstown show was great. Real nice group of people....but then again we are all vette nuts!

Howard