Thinking about getting one of their cam shafts and I was wondering do you have to pull the engine out in order to put the cam in? I am relitively good with engines but I don't have the proper setup to take the engine out! If so I will take it to a shop.

I don't think that you have to pull the whole engine out but you have to disconnect alot and tilt the engine a bit so that you can feed the new cam in at the proper angle. That is just my .02! Nice cam choice though!

That is a pretty big job if you've never done it before! Having the proper tools will be heaven sent when you start going "deep" into the engine.;)

I will be assisting in putting mine in, in about a week or so and then I will be able to give you my .02 worth of knowledge!

YOu really have to make sure you have all the proper tools because if the cam is off a degree from the crank I think you will have some serious probs!!!:(

Well luckily I have a couple buddies that are very good with engines and they have all the proper tools needed for just about any job!