tstar
07-27-2008, 12:41 AM
Materials:
Gill Lights - Neons, Cold Cathodes or LED Bars
2 SPDT 12 volt Relays
Oznium has the SPDTs and a wiring Harness;
http://www.oznium.com/relays (http://www.oznium.com/relays)
22 Gauge stranded Wire
1 Ring Crimp Spade Lug for the grounds
DIY LED Bar Link -
http://www.oznium.com/corvette_LED_shark_gills.php
Purpose of the Mod - Control the Gill lights on and off by the Fog Light switch while allowing the Gill Lights to function as Turn Signal indicators.
The Fog light switch will turn the Gill Lights on and off anytime the parking or low beams are on. The Fog lights and Gill lights are wired to the Normally Closed (NC) switch of the SPDT Relays.
The turn signals are wired to the coils of the SPDT relays, when the turn signals are activated they will open and close the relays switching them on and off.
DRL and Fog Light Relay connections. I looked for the easiest way to do this and decided to go old school. I inserted the ends of the stranded wire (flattened out and LIGHTLY tinned) into the slots of the fuse/relay centers and then inserted the relays. The wiring schematic shows the actual layout of the Relay pins/slots as you will see them in the fuse/relay centers.
I mounted the new SPDT Relays inside the battery compartment with double sided tape.
Hopefully this all makes sense once you look at your Vette's fuse and relay centers and the schematic.
http://i142.photobucket.com/albums/r117/tstar99/LED%20Mod/Gill%20Lights/78a1ecae.jpg
http://i142.photobucket.com/albums/r117/tstar99/LED%20Mod/Gill%20Lights/1adced16.jpg
Gill Lights - Neons, Cold Cathodes or LED Bars
2 SPDT 12 volt Relays
Oznium has the SPDTs and a wiring Harness;
http://www.oznium.com/relays (http://www.oznium.com/relays)
22 Gauge stranded Wire
1 Ring Crimp Spade Lug for the grounds
DIY LED Bar Link -
http://www.oznium.com/corvette_LED_shark_gills.php
Purpose of the Mod - Control the Gill lights on and off by the Fog Light switch while allowing the Gill Lights to function as Turn Signal indicators.
The Fog light switch will turn the Gill Lights on and off anytime the parking or low beams are on. The Fog lights and Gill lights are wired to the Normally Closed (NC) switch of the SPDT Relays.
The turn signals are wired to the coils of the SPDT relays, when the turn signals are activated they will open and close the relays switching them on and off.
DRL and Fog Light Relay connections. I looked for the easiest way to do this and decided to go old school. I inserted the ends of the stranded wire (flattened out and LIGHTLY tinned) into the slots of the fuse/relay centers and then inserted the relays. The wiring schematic shows the actual layout of the Relay pins/slots as you will see them in the fuse/relay centers.
I mounted the new SPDT Relays inside the battery compartment with double sided tape.
Hopefully this all makes sense once you look at your Vette's fuse and relay centers and the schematic.
http://i142.photobucket.com/albums/r117/tstar99/LED%20Mod/Gill%20Lights/78a1ecae.jpg
http://i142.photobucket.com/albums/r117/tstar99/LED%20Mod/Gill%20Lights/1adced16.jpg