hulksdaddy
07-21-2008, 07:17 PM
Radiator Shroud Install
1) Remove air bridge. It's held on with 2 plastic connectors, one on each side. Loosen boot as well, then push it aside and rest it on plenum or FRC. No need to remove anything else.
2) Pop hoses out of slots(facing the motor)
3) There are two screws on each side of the shroud. Remove them using a ratchet and short socket. The passenger side hood strut gets in the way of a ratchet extension)
4) Remove shroud
5) Reverse and you're good to go!
1) Remove air bridge. It's held on with 2 plastic connectors, one on each side. Loosen boot as well, then push it aside and rest it on plenum or FRC. No need to remove anything else.
2) Pop hoses out of slots(facing the motor)
3) There are two screws on each side of the shroud. Remove them using a ratchet and short socket. The passenger side hood strut gets in the way of a ratchet extension)
4) Remove shroud
5) Reverse and you're good to go!