I just bought a 96 vette conv. And I want to try to put it on four jack stands to work on brakes & detail the suspension.I dont see where i can lift it in the middle or where i could place the jack stands with out damage.any tips?

http://www.zr1netregistry.com/jackupzr1.htm

the frame is always a good place to go! Nice, I just looked at the link given to you right above and that will lead you in the right direction!:thumbsup:

Very good instructions! I recently jacked up my 1992 to do a bearing/hub change and found that if you can't get your jack under the car, just drive it up on a few flat pieces of stagered plywood to give you that extra height you need. Make-shift wheel ramps:burnout: