I have a 1993 Corvette LT1, and I have the "Change Engine Oil" light on on my dash. Question: How do I turn it off?

I have a 1993 Corvette LT1, and I have the "Change Engine Oil" light on on my dash. Question: How do I turn it off?
The "Change Oil" indicator is reset by using a sequence of Driver Information Center (DIC) key presses as follows:

1. Turn ignition "ON", but do not start engine.

2. Press the "ENG/MET" button and release, then, within 5 seconds, press it again.

3. Within 5 seconds of Step 2, press and hold the "GAUGES" button. While the button is held, the "Change Oil" indicator will flash.

4. Continue holding the "GAUGES" button until the "Change Oil" indicator stops flashing and goes out, indicating successful completion of the reset cycle. This should take about 10 seconds.

If it does not successfully reset, turn ignition "OFF" and repeat the procedure from Step 1.

The "Change Oil" indicator is reset by using a sequence of Driver Information Center (DIC) key presses as follows:

1. Turn ignition "ON", but do not start engine.

2. Press the "ENG/MET" button and release, then, within 5 seconds, press it again.

3. Within 5 seconds of Step 2, press and hold the "GAUGES" button. While the button is held, the "Change Oil" indicator will flash.

4. Continue holding the "GAUGES" button until the "Change Oil" indicator stops flashing and goes out, indicating successful completion of the reset cycle. This should take about 10 seconds.

If it does not successfully reset, turn ignition "OFF" and repeat the procedure from Step 1.

I'll be keeping this post as a favorite!