How does one change the rear license plate on a "99 C5?

Dan

How does one change the rear license plate on a "99 C5?

Dan

2 screws are what are holding mine down with. Phillips screw driver and 3 minutes you should be good.

I remove two screws but the frame (and attached baskup lights) is still being held on by something else

I just went and looked at mine and its just 2 screws holding it in???

I (again) just removed the only two screws visable holding the license plate inside the frame. With them removed the frame is still tightly held to the car. No other screws are visable. The is no apparent way to get access behind the frame/plate (short of dismantling the car!). Interestly I know changed the plate 4 yrs a go, but don't remember how. Clearly must be somethign simple. Owners manual makes no mention.

I (again) just removed the only two screws visable holding the license plate inside the frame. With them removed the frame is still tightly held to the car. No other screws are visable. The is no apparent way to get access behind the frame/plate (short of dismantling the car!). Interestly I know changed the plate 4 yrs a go, but don't remember how. Clearly must be somethign simple. Owners manual makes no mention.

there are 4 tabs that need to be depressed on top and bottom of tag frame,use a small flat screwdriver,be careful,they break easy!:cheers:

Thanks. Done!

Dan

That was weird! Now I gotta go outside and check mine.

That was weird! Now I gotta go outside and check mine.

:smack: I'm making the mental point to do the same. I put the plate on my car and thought it was just 2 screws? :confused: :lol: