|
: What would shop charge to install hardened output shaft? David Farley 06-14-2009, 11:28 AM What can I expect a shop to charge to install a hardened output shaft in my C6? I just found out it's not a DIY'er job so might as well get the feelers out to see what sort of cost I might be looking at. :thumbsup3: drivinfast 06-14-2009, 06:04 PM Might as well get both right and left. there about $250 apiece. To drop the cradle labor is $400. Take one shaft off, take to bench and swap it for the hardened and hour so $100. So maybe $500 or more David Farley 06-27-2009, 08:15 AM Might as well get both right and left. there about $250 apiece. To drop the cradle labor is $400. Take one shaft off, take to bench and swap it for the hardened and hour so $100. So maybe $500 or more Thanks for help, so are you saying total cost is roughly around $250 each or $250 plus the $500? drivinfast 06-27-2009, 08:44 PM Thanks for help, so are you saying total cost is roughly around $250 each or $250 plus the $500? Start over just one shaft. Drop cradle and then reinstall $400 One shaft part $250 install one shaft $100 Total = $750 but my rear end cradle has always been out for something so the shafts were just an additional item Maybe the tire can be taken off, then the components to take the hub off and then put the new shaft in. so the cradle wouldnt have to be dropped. I would say thats doable but it would be say $100 or so less. | |