Its cold in NY! Anyway I want to remove my seats, console, and carpet to run some new electronics and dynomat. Does anyone have experience or have diagram on proper steps to do this? Basically is there anything I need to look out for or be careful with?

Appreciate the help.

Todd

It is pretty straight forward as far as taking out the center counsel and the seats. The center counsel is pretty much all clips and there are a few screws in the compartment. So once you get the screws undone from inside the center counsel and you will want to take off you shifter knob, then pull fiirmly, yet carefully, and it should pop off. The seats are primarily just the (4) bolts on each corner of the seat and unpluging the wires to the electric seat. That should get you past the most difficult parts of what you are trying to do! Good luck!

Greg.

If you want, feel free to give me a buzz and I can walk you through it real quick.. Its pretty easy

If you want, feel free to give me a buzz and I can walk you through it real quick.. Its pretty easy

Thats what I call service! I may end up calling you guys up with questions on my build! Appreciate any help that you might be able to give.

Chris and Smokinvette2, thank you both. Actually after opening gifts yesterday we finished pulling everything out. It was kind of easy, a few parts gave us some problems. More just a pain to access.

Chris, thanks for offering the phone support! I'll keep that as a "ace" for furture more challenging problem or question. Count on that. :)