Okay can i put a cam for an lt motor in my 84 tbi

Anything can be put into anything, but the factory roller cams are not a direct replacement for the flat tappet cams. Also you don't have a cam driven water pump or distributor. Depending on what you really want, it will likely cost more to adapt that LTx cam than to buy the right parts from the start.

RACE ON!!!

some one plz tell me what motor i have and where to by parts cause i've been looking and don't know!!!!!!!!! oh yea forgot 84

some one plz tell me what motor i have and where to by parts cause i've been looking and don't know!!!!!!!!! oh yea forgot 84

L83 350. Flat tappet cam
Any SBC parts from 1957-1985 will fit
Maybe not the right ones but they will fit:thumbsup3:
Look for a cam listed as flat tappet , not hyd roller
Summit , Jegs and any other place that sells perf parts.

some one plz tell me what motor i have and where to by parts cause i've been looking and don't know!!!!!!!!! oh yea forgot 84Your opening post said:Okay can i put a cam for an lt motor in my 84 tbi
As vetteoz said, it is an L83.

RACE ON!!!

Any SBC parts from 1957-1986 will fit
Maybe not the right ones but they will fit:thumbsup3:
Good luck using the block, crank, or oil pan, each alone with out using all three in a pre 1986 assembly. Other than that, pre 1957, back to 1955, SBC parts interchange also.

RACE ON!!!

Your opening post said:
As vetteoz said, it is an L83.

RACE ON!!!

Because of the injection system your motor is called an L83, but underneath the crossfire injection, it is just a 1st gen small block, anything from 86 back will work. :cheers:

compcams dot com. they will help you select the right cam for your set up...

but underneath the crossfire injection, it is just a 1st gen small block, anything from 86 back will work. :cheers:
Except as stated above, the 1986 block, crank, oil pan, and (which I forgot, above), the flywheel, or flexplate. Chevy went to the one piece rear main seal in 1986, which changed those parts. The aluminum heads (interchangeable, watch the CR) were phased in during the 1986 model year and the roller cam (not directly interchangeable) came in 1987.

RACE ON!!!

Thanks guys i was so confused!!!! And would yall say possible with cam and head and chip look at 350 RWHP

And would yall say possible with cam and head and chip look at 350 RWHP

With NOS maybe
Need to port the intake big time CFI-EFI is the man for info

Check out http://www.crossfire.homeip.net/